Nagios can be used to directly monitor the XCP dom0 host. If you wish to do more than just ping the dom0 host, you'll need to install NRPE on the XCP dom0 directly.
Please note the below instructions are not perfect as they don't necessarily install all the dependency packages needed by all of the available Nagios plugins (e.g. SNMP libraries, etc).
XCP comes with iptables installed and enabled by default. You will either need to explicitly enable the services in iptables that you would like to allow through (e.g. NRPE port 5666), or if your system is already secure behind a firewall, you can completely disable iptables like this:
/etc/rc.d/init.d/iptables stop chkconfig --del iptables
A quick install for NRPE and the nagios plugins can be done like this:
#packages for 32-bit centos5 wget http://pkgs.repoforge.org/fping/fping-2.4-1.b2.3.el5.rf.i386.rpm http://pkgs.repoforge.org/nagios-plugins/nagios-plugins-1.4.15-2.el5.rf.i386.rpm http://pkgs.repoforge.org/nagios-nrpe/nagios-nrpe-2.12-1.el5.rf.i386.rpm rpm -ivh fping-2.4-1.b2.3.el5.rf.i386.rpm rpm -ivh nagios-plugins-1.4.15-2.el5.rf.i386.rpm --nodeps rpm -ivh nagios-nrpe-2.12-1.el5.rf.i386.rpm
Some of the custom plugins I use require sudo, so I chose to enable running all plugins as root. This is a security risk and so should only be done if needed.
visudo # Comment out the line for "Defaults requiretty" # Add the line "nagios ALL=(ALL) NOPASSWD: /usr/lib/nagios/plugins/" vi /etc/nagios/nrpe.cfg # Enable the line for command_prefix with sudo # Modify the commands as you would like, in particular I added the disk check: # "command[check_disk1]=/usr/lib/nagios/plugins/check_disk -w 10% -c 5% -p /dev/sda1" # Modify allowed_hosts to enable access from your Nagios machine: e.g. "allowed_hosts=192.168.1.20" chkconfig --add nrpe service nrpe start